Bioresonance Device

£160.00

In stock

Description

Bioresonance Device

Instructions for the use of the Bioresonance device​

DO NOT USE IF YOU ARE PREGNANT OR THINK YOU MIGHT BE​

DO NOT USE IF YOU HAVE A HEART PACEMAKER OR ANY OTHER ELECTRICAL DEVICES IN YOUR BODY​

Remove all metal that touches your skin except difficult to remove rings.​

  • Insert a 9v PP3 battery into the compartment at the back of the bioresonance device. Always keep a spare battery
  • Take both copper electrodes and insert the leads into the sockets of the device
  • Avoid the copper electrodes touching each other when the device is turned on. It will flatten the battery very quickly
  • Do not touch your hands together when holding the electrodes and the device is on​
  • Sip a glass of warm water throughout the process, your liver needs it
  • Hold the electrodes, one in each hand and switch the device on using the circular button on the front of the device
  • The blue light will come on to show you it is on. If it dims or does not come on, replace the 9v battery
  • If you cannot hold the electrodes in your hands, place the connected electrodes on a dry towel on the floor and place your bare feet onto the electrodes or place them in your armpits
  • Use the device for 10 minutes with a 10 minute rest
  • Do that three times consecutively (we call it a ‘3 timer’)
  • If you are well and want to keep well, do a 3 timer once a week especially if you have pets
  • The bio-resonance device is not waterproof

If however, you have symptoms of cold or flu or suspect you have a parasitical, bacterial or viral infection or you have had a surgical or accident wound, do a ‘9 timer’ (nine consecutive sessions 9 x 10 minutes with a 10-minute rest gap between).

Leave one day to rest, then complete a ‘3 timer’ every day for the following 5-7 days. Even though most of the bad bugs will have gone, with some viruses, loss of taste, smell and some other symptoms it can take longer for the body to repair. You may still test positive for a virus a week or so afterwards especially if your lymphatic system is slow. Any virus test may still detect pieces of a shattered virus.​

You cannot stop pathogens infecting you. For 98% protection against them causing your symptoms, do a ‘3 timer’ once a week to remove all new bugs and remain disease-free. Walking or exercising afterwards is important as it increases the lymphatic flow to expel the dead bugs. A lymphatic drainage massage is highly recommended after or during your treatment.

 

Doing a ‘9 timer’ will be 100% effective in destroying viruses, bacteria and parasites.​

Periodically, clean the copper electrodes with a scouring pad to bring back the shine, it greatly helps the conductivity.​ You may experience spots or small bumps appearing on your skin when you use the device. If so, stop using it for a few days and everything will disappear. This is caused by a slow lymphatic system as the body is pushing dead pathogens to the outside until it can deal with them. Drink at least one and a half litres of water (preferably warm) a day to help flush out the dead bugs.​

Please journal your experiences, the good and the bad. Sometimes there are viruses that hide and reappear after your session. You may feel tired after the first few times or the 9 timer as your system is removing a lot of garbage. Some people (especially if you are currently unwell) may feel totally drained after a 9 timer. We would strongly advise that you do not to work or have a busy day following.​

TEST LED​

To test that the bioresonance device is working, turn on the device. Make sure the copper electrodes are connected. Take one LED lead and hold it against one of the copper electrode bare ends and touch the other electrode with the other wire of the LED. ​ If it does NOT light, then change the wires round (as the LED test only works one way). If after swapping the wires around the light still does NOT go on, then replace the battery.

​​

“Life is a real challenge when you lose your health. Take care of your precious body.”